Faculty of Engineering
Department of Manufacturing Engineering
Faculty of Engineering
Department of Manufacturing Engineering

 

ANNALS OF “DUNAREA DE JOS” UNIVERSITY OF GALATI

Fascicle XII, WELDING EQUIPMENT AND TECHNOLOGY

ISSN 1221-4639

 

Call for Papers

The deadline for receiving your contributions is 31st May 2017. 
Note: The submission process is continuous. The papers submitted after 31st May 2017 will be evaluated for the next volume.

 

Submission of papers

 

Submission via e-mail (preferred)

The authors should send the contributions in Microsoft Word (.doc) or Adobe Reader (.pdf) to the e-mail addresses from below.  The final version it is mandatory to send in Microsoft Word document non-protected version of the contributions including the Copyright Agreement form. It is strongly recommended to use the Paper Template provided in the Instruction for Authors section, even in the initial phase of the review process.

 

Submission via regular mail

Authors should submit 3 (three) hard copies of their contribution by ordinary post to the contact data written below. If you choose to send the paper via regular mail, please firstly send an e-mail with the proposed contribution title to one of the following e-mail addresses.

 

Annals of “Dunarea de Jos” University of Galati, Fascicle XII, Welding Equipment and Technology

Dunarea de Jos University of Galati, Faculty of Engineering

Department of Manufacturing Engineering
111 Domneasca St., 800201 - Galati, Romania
Tel: +40 336 130212, Fax: +40 236 314463

 

Prof. Dr. Eng. Elena SCUTELNICU
E-mail: elena.scutelnicu@ugal.ro

or

Assist. Prof. Dr. Eng. Carmen Catalina RUSU
E-mail: carmen.rusu@ugal.ro